Looking for a VG or Dimension

[bigdog85222]

Looking for a VG or Dimension to buy or trade with cash. LMK

[Stormed1]

What weight?

[JaxBowlingGuy]

I have a 15 dimension.. Low games, plugged once but redrill right back into fingers and thumb slightly.. The person I bought it from has big fingers and used the big grips and the holes were too big for the standard 31/32 hole.

[bigdog85222]

I am looking for a 15lb ball. Got any pics?

[JaxBowlingGuy]

I'll take a few tonight

[bigdog85222]

I meant to ask you as well.....what is the span of this ball cut to cut?

[JaxBowlingGuy]

4 7/8 to middle and 5 to ring.. If not its very close to this..

[JaxBowlingGuy]

Here are some pictures... The white in the pix is apart of the ball.. The balls was resurfaced and heat cleaned then put up and hasnt been thrown since... that was the 1st and only time it has been resurfaced and I only went down to 360. It was not resurfaced due to damage, but to just remove surface scratches from old wood lanes.. The ball is in very good condition..

[JaxBowlingGuy]

Only fingers and thumb was pluged.. The weight hole stayed the same.

[Stormed1]

Just an FYI they make a reducing sleeve to insert in the 1 1/32 holes the grips of 53/64 and larger require. This sleeve reduces the hole to 31/32 so you don't have to plug the fingers. htey are available in black and whitee

[JaxBowlingGuy]

Yea, the shop i had that done at doesnt carry any "special" items.. they are lucky to have balls in stock.. Tonight went to had a ball done and didnt have my grip size.. either of them.. if my driller didnt work there and if i didnt get it dirt cheap i wouldnt go..

[bigdog85222]

So are you saying that finger grips are to small to put into the finger holes and I would need a reducer in order to put grips in? So what would you sell this ball to me for....shipped to 85222?

[JaxBowlingGuy]

After checking shipping, you will probablybe better of getting one off ebay.. Your looking at $55-$60 shipped... $26 is shipping alone