J How
10-19-2010, 10:02 PM
Not only does this ball look great, but it is another great product from the folks at Motiv. I tried a layout on this ball that I have had a lot of success with on other balls, and this ball out preformed both of the previous balls. I drilled this one at 30x40x4.5" pin(will still need a weight hole). This reaction was very smooth and the ball still broke hard off of the spot. Even if you have the QZ1's this ball is a must have! Great Job Motiv!
Justin Howard
Motiv Regional Staff
Justin Howard
Motiv Regional Staff