PDA

View Full Version : Rising Star Ball Review



RonCase823
09-06-2011, 01:00 PM
My Axis is 5 5/8 right, ¼ up, my speed is average and I would consider myself with higher revs but more up the back. So not a cranker but not really straight either.

Drilled this one pretty simple. Put the pin 4” from PAP and the CG 5” from PAP.

This ball goes very long then snaps quite hard on the back end. It covers more boards than I originally expected. It works great when the heads are fried. Just be sure it’s the heads that are fried and not the mid-lane or it may hook too soon unless you have lots of speed.

I’ve also scuffed the surface and found it makes a very nice smooth arch which works well on some wet-dry conditions.

This ball will work well for those that need some help getting the ball through the fronts. If it is too skid flippy don’t forget you can scuff the surface and tame it out.