Wet vs Dry Sanding
This ball was sanded with the same grit, left-dry sanded, right-wet sanded.
Wet sanding produces a more sheen like finish, water acts as a lubricant to a point so the cutting isn't as aggressive.
Also wet sanding helps keep the dust and friction heat down, the water also helps reduce buildup of the cuttings in your pad/paper which let's them cut better and last longer.
Wet sanding is pretty much the standard when using a home spinner.
Dry sanding is a bit more aggressive and will give you a duller surface. But you get more friction which generates more heat and the pad can load up which can reduce the effectiveness of the cutting.
fyi:
Daily maintenance is the key to good coverstock performance. The most important step is to clean the ball thoroughly by hand with a good bowling ball cleaner immediately after each use before the oil can get deep into the coverstock. Preventing deep penetration of the oil into the coverstock is better, easier, and cheaper than trying to remove the oil after it gets deep into the coverstock!
Bookmarks