How many pieces of thumb tape do you use to snug up?

[Hammer]

In my current ball I usually put in 4 pieces of thumb hole tape to snug it up a little. The idea is to layer them so they are just a little below each other instead of putting them one on top of another. If my thumb starts to hang up I take one out. Did you ever use more then 4 or less then 4 to be sufficient
enough to snug up? Do you use rough or smooth surface thumb hole tape?

[J Anderson]

Depending on the ball, since some of mine are drilled a bit bigger than others, its usually only one or two pieces of the textured thumb tape. I've had up to 4 or 5 pieces, but last Sunday I had to take every piece out of the three balls that
I used that day.

[MICHAEL]

does it make a differance where you put the tape? front/back/side of thumb? I might start experimenting with the tape! I have 3 thumb inserts that are too lose!

[Hammer]

does it make a differance where you put the tape? front/back/side of thumb? I might start experimenting with the tape! I have 3 thumb inserts that are too lose!

The recommended location for thumb hole tape is where the pad of your thumb goes in and out of the ball. Also put your fingers into your ball and then your thumb and pull your thumb out slowly to see where the pad of your thumb is laying in the thumb hole when you pull it out. The pad of your thumb is not facing your fingers. It is facing in a different direction then your fingers. So under the thumb pad is where you want the tape.

[Zothen]

1 piece rough tape and thumb tape back of thumb.

Zothen

[J Anderson]

1 piece rough tape and thumb tape back of thumb.

Zothen

I assume rough tape in the ball where the pad of the thumb will rest, and skin protection tape to the back of the thumb itself.

[HughScot]

I used to have thumb problems and used whatever # of pieces were necessary. I finally had a new ball drilled with some forward pitch and then a hair too large so I could adjust with just one or two pieces at the nail side of my thumb. Your thumb is oval so, if necessary, make sure the sides of the hole are enlarged to fit your thumb. I had a helluva time and thought it was just me but when drilled properly and shaped in a slight oval it made all the difference in the world. I've never had to use tape on the pad side of my thumb but some folks do.

I've used every form of bowling tape made and it's through experimentation that I went with the white tape, not super smooth. But it's a personal thing.

[billf]

I use it as designed; textured to the front and slick on the back. The amount of tape varies depending on swelling/size of the thumb that day.

[noeymc]

i just put it on the back of mine

[Stormed1]

As my hands are very dry do to some meds i take i use rough on the front and Vise Hada #3 on my thumb. I ahve anywhere from 2-8 pieces in the ball. At any more than 4 I go to black tape at the back so as not to change the span. On 90% of my balls i will just awitch to a smaller/larger IT as needed. I still haved 3 or 4 balls without the IT and those tend to uses the most tapw