Nice to see you committed to changing up the swing. IMO, don't get hung up on game scores for now. When changing mechanics, your scores will get worse before they get better. (Your timing will be off for awhile, for sure.) The long-term benefit is that you'll have a higher ceiling if you successfully grasp the changes.
So let's stick with adjusting your steps. JaMau24 pointed out your starting stance. Typically, right-handers start with the feet together and the left foot a couple inches in front of the right. This slightly opens the hips and gets them pointed over towards the target arrows. Norm Duke says the starting position is about getting the feet, the hips, and shoulders in agreement. Sounds kind of gimmicky, but I think it works.
An overlooked benefit of having the feet together has to do with spine tilt (how much you lean over to the right). The good news is that you are doing a nice job of keeping your spine tilted after your first step. However, it's easier to set your spine tilt when you are standing still than to do it while moving your feet and arms together. Bowling is all about repeatability, so on the approach keep the feet together, set the spine tilt, and then start your steps. You'll have a consistent spine tilt that way.
You have a good crossover step with the right foot, but I am not sure what rule of thumb you follow afterwards. I see both cases where your steps are like walking on a tightrope and the other where your left foot does not come back directly in front of the right foot on step #2. Many are coached to step a few boards to the left (w/ the left foot) in order to keep the ball from tucking behind their back on the backswing. Unless you need to do it to keep your swing straight, stick to the tightrope steps for now.
The last two steps of the release go hand in hand. Make the last right-footed step a little shorter than the others, and that will get you to actually slide on the last step with the left. Watch the Chris Barnes video again (link) and see how he does it. Note how far Chris's slide foot travels is in front of his body. He can do this because of the push off from his 3rd step. (I emphasize here that it's very important that your shoes match the condition of the approach. That's the reason for the interchangeable slide soles on high performance shoes. As an alternative, you can use a dusting of Ebonite Ultra Slide powder on the bottom of your shoe if you're sticking.) Currently, it looks like you are stepping into the shot during your release.
I know it looks like a lot to think about, but you have some good qualities to your footwork already. Just do a quick checklist:
- start with feet together, left a little in front
- set spine tilt
- step with feet in front of each other (unless you need to straighten out your swing)
- short 3rd step, then slide
Bookmarks