Mental Anguish! Frustration! Possibilities!!

[stumblintowards100]

Just some suggestions:

Assuming the sheet that was found was your grip spec's (Span's, Pitches etc.) and which might Possibly include the layout used on the Critical Theory

1- Double check the fit.
2- I would have your PAP location checked also. If you have a couple of balls, bring them and throw a few frames. Get a good measurement.
(If possible check your speed and rev's and tilt etc while your at it. That will help in choosing a layout.)

That's the main plan

3- just do one ball at first, so you can try it out. That way you can be sure of the grips fit, before for doing the others.

Depending on which & how many balls you have and want to change. I would only do a couple of "strike" balls and your spare ball if you have one.

Make sure you discuss with the driller what your looking for the ball to do or expect to do after drilling. (Think about what your ball has been doing and what you'd like to see it do)

LOL, the ball has been "missing" a lot, I want it to "hit" a lot! lol (couldn't resist lol)

Might be a good time to have the balls surface freshened up too.

That's one thing I do. I have a "hot box" w/ rollers and a spinner. Plus, the local guy helps me keep them as "fresh" as possible.

Thanks for your suggestions

[rv driver]

It almost sounds like the grip was right, the layout was good, if you describe the ball as comfortable and your average jumped that much. Sounds like the ball needs resurfacing or something. But I'm definitely not the expert on equipment here.