didn't show how to get the old ones out...lol...I'm sure I can find it. My pso charged 15 to change them
“There’s nothing like throwing a 16lb 8.5 inch sphere at 10 3.5lb wooden objects spaced 12 inches apart and having them all hit each other” proud member of Bowlingboards.com bowling forums and ball contest winner
Here you go Lou this will get those inserts out Columbia 300 Insert Puller just as longOriginally Posted by LOUVIT
as they are 31/32" diameter inserts. I could only use one for one insert on my ball as the
other insert is I believe 1 1/32 in diameter so I just use my pocket knife to get them out
and it is cheaper on me that way too. LOL!!!!!
I am a proud member of Bowlingboards.com bowling Forums
Right handed, ex-cranker now a power tweener approx. 350 - 400 RPM's PAP 4 1/2" over 1" up high league sanctioned game 300 high league sanctioned series 788
Bill
There's many ways to remove them, Like I take a pocket knife and slip the blade down the side of the insert and just cut it loose and pull it out.
Right handed Stroker, high track ,about 13 degree axis tilt. PAP is located 5 9/16” over 1 3/4” up.Speed ave. about 14 mph at the pins. Medium rev’s.High Game 300, High series 798
"Talent without training is nothing." Luke Skywalker
I really like that insert tool. Anyone ever use one on here?
I glue inserts using the 3 6 9 method. Lol...and on the filler is where I glue my inserts. I use gel glue by loctite and use s tiny drop on the three sides, I don't over glue. Also, I use a 1/8" flat head screw driver to remove the inserts. I did have and use a insert tool before, but I do a cleaner job with a screw driver.
https://2ecffd01e1ab3e9383f0-07db7b9...dcb9c5572c.jpg
Is this the one you use fokai? I'm looking to maybe start doing my own. I tried using a small screwdriver but it felt like I was putting a lot of force on the edge of the finger hole. That's why I liked that tool.
https://www.amazon.com/Loctite-Ultra...ite+super+glue
you can use that, but I prefer this one.....
Posting Permissions
Bookmarks