question on new ball I just had drilled

[Stormed1]

Actuall balls drilled pin down being earlier is not the truth at all, Basically pin up balls respond to friction quicker so therefore are more andgular at the breakpoint. Pin down balls respond to friction slower and as such are smoother or archinhg at the breakpoint

[striker12]

ok ik how your ball is drilled its drilled for length with a sharp backend i have same thing but with pin under fingers but mines drilled for length with a strong arc ment for dryer lane condtions well to tell you will your ball is drilled to give big snap on the backend but little tip dont open up the lanes much on heavy oil stay to about 10-15 boards crossing and u will have a nice smooth move to the pocket and when the lanes get dryers you can start opening up alittle but if y0u go with my dirlling pin under i have togo streght up 10 but i can use it on any oil condtions but if you want to know about the patterns u mgith see out there...there are some sites that u can check that up on and see how long they are alittle thing if a pattern is long stay close to the right abit and dont cross boards over 10 but says its the cheeta pattern u will have to stand left alot play throw the middle out to 10-5 board and it will snap back in cause the outter part of the lane has abit of oil andits the shortest pattern at i think 34-36 feet soo theres alot of dry area soo u want to paly threw middle throw the oil to get some carry on the backend