I'm not too sure, I just take my equipment to my local pro shop and he does it for about 5$
Right handed Stroker, high track ,about 13 degree axis tilt. PAP is located 5 9/16” over 1 3/4” up.Speed ave. about 14 mph at the pins. Medium rev’s.High Game 300, High series 798
"Talent without training is nothing." Luke Skywalker
I'm not too sure, I just take my equipment to my local pro shop and he does it for about 5$
I am a proud member of BowlingBoards.com Bowling Forums
whenever i do this, the duct tape doesn't seem to keep the water out of the holes. any sugguestions?
I seem to have that problem too. it's really not THAT big of a deal though. just sit the ball with the finger holes facing down and gravity takes care of the majority of the water. a little blowing in them, and then just let it sit. as long as your not bowling that day with the ball it shouldn't be a big deal
i put mine in the oven on 175 for about 20 minutes. get rubbing alcohol, lots of oil will come out, rub the alcohol on the ball with a towel
Right handed Stroker, high track ,about 13 degree axis tilt. PAP is located 5 9/16” over 1 3/4” up.Speed ave. about 14 mph at the pins. Medium rev’s.High Game 300, High series 798
"Talent without training is nothing." Luke Skywalker
if i was going to do my ball in the oven then i would only do it at 50 degrees no higher and every like every 3-5minutes then circles the ball keep every part of the ball even then take it out for about 2hrs then put back in for abit
League ave. 180; high league game 277; high league series 695
Current weapons - Blue Hammer; Green/gold Ebonite Cyclone - both 15lbs.
Bookmarks