I'm sorry I'm making you mad by commenting on your posts.
This make no senseAbout the vertical axis line, one end of that line is 4 3/4" down for some people, but the other end of that line is 6 3/4" from the grip center on a line that goes thru the fingers. And thats the same dimensions for everyone.
See post aboveBTW how do you find the Vertical axis line for someone with X down and 0 over?
Also it's not "X down and 0 over" it would be "X over and O up or down(depending if the PAP is above or below the Midline)
The balls holes would be oriented like in the post above when getting the measurements off the ball.
Yes you located the PAP with 1 distance, and one angle, But if you don't know what that 2nd angle is before you try to layout a ball. You won't be able to project the line from the PAP at the correct angle to locate the grip center.I don't need three measurements to find the PAP. only 2. 1 distance, and one angle. The other angle measurement is useful later.
So you would have to measure that 2nd angle also, when you do the other measurements. And to do that you would need to have the Vertical Axis Line. And if you have that you don't need your angle measurements in the first place. just use the regular measurements and save having ti do more steps.
Your method doesn't tell you anything the other method doesn't. What about the current why of doing it , does it not tell you?To me each time you have a choice between two apparently equal options you should select the option that provides the most useful information.
The cake has failed to rise yet.Again wait until the cake is done cooking before you decide if it tastes bad.
Bookmarks